-
Archives
- February 2012
- January 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- July 2011
- June 2011
- May 2011
- April 2011
- March 2011
- February 2011
- January 2011
- December 2010
- November 2010
- October 2010
- September 2010
- August 2010
- July 2010
- June 2010
- May 2010
- April 2010
- March 2010
- February 2010
- January 2010
- December 2009
-
Meta
Tag Archives: GLUE
Lonelybot.com – 4/5/10 Sanding, Epoxy Basecoat
I’m back!! Running headlong towards exterior fiberglass, today the hull prep is finished. Duration : 0:1:44
Posted in exterior plywood
Tagged autonomous, Boat, build, cable, cabletie, cableties, cleaning, control, crossing, deck, electric, epoxy, fiberglass, filler, garage, GLUE, installation, lonelybot, ocean, oceancrossing, plywood, prep, rc, remote, resin, robot, SANDING, satellite, scratch, stitch, stitch-n-glue, tie, ties, UAV, USV, Wood
1 Comment
Lonelybot.com – 2/8/10 Hull Prep part 2
More hull sealing and sanding before exterior fiberglass… Duration : 0:1:14
Posted in exterior plywood
Tagged autonomous, Boat, build, cable, cabletie, cableties, cleaning, control, crossing, deck, electric, epoxy, fiberglass, filler, garage, GLUE, installation, lonelybot, ocean, oceancrossing, plywood, prep, rc, remote, resin, robot, SANDING, satellite, scratch, stitch, stitch-n-glue, tie, ties, UAV, USV, Wood
Comments Off
Notso 16
This is a Stitch and Glue Kayak available in plan form from www.greenval.com, Kit form from www.noahsmarine.com and complete from www.handcraftedcanoes.com. The Notso 16 is a 16 foot marine plywood kayak. Made using cnc cut panels, assembled with epoxy and … Continue reading
Lonelybot.com – 1/30/09 Stitches Removed, Hull Prep Part 1
Finally the stitches can be removed and I can start prepping the hull for exterior fiberglass. Duration : 0:2:28
Posted in exterior plywood
Tagged autonomous, Boat, build, cable, cabletie, cableties, cleaning, control, crossing, deck, electric, epoxy, fiberglass, filler, garage, GLUE, installation, lonelybot, ocean, oceancrossing, plywood, prep, rc, remote, resin, robot, SANDING, satellite, scratch, stitch, stitch-n-glue, tie, ties, UAV, USV, Wood
1 Comment
Home Built Canoe – Highlights
This canoe is a Selway Fisher Guide 18 made using 5 sheets of 6mm exterior ply. The planks are stitched together with wire, then glued using epoxy resin. It was a lot of fun to build. At 18 foot i … Continue reading
stuccoboard and trim repairs part two
Step by step procedure for a badly rotten stuccoboard area behind some rotten vertical trim: (replacing piece of stuccoboard as well) Pull out nails with nail puller and/or hammer scrape off all loose wood and stuccoboard remove caulk at area … Continue reading
Posted in exterior plywood
Tagged abitibi, acrylic, aluminum, board, budget, caulk, cedar, cheap, composite, Cost, cottage, decay, deck, DIY, do, drip, edge, edges, English, epoxy, exterior, failure, flashing, flashings, Foam, GA's, ge, GLUE, hardener, heating, home, house, inexpensive, insulation, it, masonite, miratec, nails, natural, paint, pcproducts, plywood, Polyurethane, preservative, prevent, preventative, primer, repair, rot, rotting, rubber, save, screws, silicone, stop, stopping, Stucco, stuccoboard, style, t111, tape, treated, trim, tudor, warp, warping, warranty, Wood, yourself
Comments Off
stuccoboard and wood trim repairs part one
My home’s exterior is stuccoboard and rough-cut cedar trim. It was built in 1979 and about 25% of the cedar trim was replaced in 1993 when I moved in. I pretty much neglected the wood after I moved in. I … Continue reading
Posted in exterior plywood
Tagged abitibi, acrylic, aluminum, board, budget, caulk, cedar, cheap, composite, cottage, decay, deck, DIY, do, drip, edge, edges, English, epoxy, exterior, failure, flashing, flashings, Foam, GA's, ge, GLUE, hardener, heating, home, house, inexpensive, insulation, it, masonite, miratec, nails, natural, paint, pcproducts, plywood, Polyurethane, preservative, prevent, preventative, primer, repair, rot, rotting, rubber, save, saving, screws, silicone, stop, stopping, Stucco, stuccoboard, style, t111, tape, treated, trim, tudor, warp, warping, warranty, Wood, yourself
Comments Off
Lonelybot.com – 4/11/10 Exterior Fiberglass
The first half of the fiberglass cloth goes on. Duration : 0:0:59
Posted in exterior plywood
Tagged autonomous, Boat, build, cleaning, cloth, control, crossing, electric, epoxy, fiberglass, fill, filler, garage, GLUE, lonelybot, ocean, oceancrossing, plywood, prep, rc, remote, resin, robot, SANDING, satellite, scratch, stitch, stitch-n-glue, UAV, USV, weave, wet-out
Comments Off
how to build a kayak, night one
gday everyone my names sid and iv jst started to build a stich and glue kayak. im 16 and have been researching and designing this for about a month now and have come up with some nice plans. how to … Continue reading